Android的Galaxy S的电话 - 在Mac OSX ADB调试桥故障 [英] Android Galaxy S Phone - ADB Debug Bridge Trouble on Mac OSX
问题描述
下面是个问题。我这样做是为了获得设备列表:
Here's the issue. I do this to get the device list:
./adb devices
和我得到这样的:
List of devices attached
,没有返回的设备。如果我运行模拟器,显示上面的列表中,但仍然没有物理设备。
with no returned devices. If I run the emulator, that shows on the above list, but still no physical device.
我使用的是三星Galaxy S Fasciate(Verizon的模型)在MacBook上运行OS 10.5。
I am using a Samsung Galaxy S Fasciate (Verizon model) on a MacBook running OS 10.5.
我连接通过为被告知在不同的留言板供电USB集线器(我能找到源头,如果任何人的兴趣)。当我直接连接这也不起作用。
I am connecting through a powered USB hub as was advised on a different message board (I can find the source if anyone's interested). This also does not work when I connect directly.
根据MAC系统概述,该设备插入:
According to the Mac System Profiler, the device is plugged in:
SAMSUNG_Android:
Product ID: 0x681c
Vendor ID: 0x04e8 (Samsung Electronics Co., Ltd.)
Version: 2.23
Serial Number: I500874368c4
Speed: Up to 480 Mb/sec
Manufacturer: SAMSUNG
Location ID: 0xfd140000
Current Available (mA): 500
Current Required (mA): 96
我能够挂载SD驱动器,甚至已经成功地使用了两个的系绳通过USB电缆连接到互联网不同的应用程序,这样我就可以放心地假设计算机可以正确地与设备进行交互。
I am able to mount the SD drive and have even successfully used two different apps that tether an internet connection via the USB cable, so I can safely assume that the computer can properly interact with the device.
然而由于某些原因,它不作为本人可以调试一个设备显示出来。
Yet for some reason, it does not show up as a device that I can debug.
(是的,我已经打开USB调试在手机上 - 甚至试图重新启动手机)
(And yes, I've turned on "USB Debugging" on the phone - and even tried restarting the phone.)
我将不胜AP preciate任何帮助这一点。
I would greatly appreciate any help with this.
推荐答案
明白了!
这是EasyTether!
It was EasyTether!
我装EasyTether在某些时候,它干扰了这个即使我想我卸载它。
I installed EasyTether at some point and it was interfering with this even after I thought I uninstalled it.
下面是从EasyTether网站解决方案:
Here's the solution from the EasyTether website:
亚洲开发银行在Mac OS X终止确认该 安装后,连接的设备 EasyTether驱动程序。使用 kextload / kextunload从卸载 内存EasyTetherUSBEthernet.kext 手动内核扩展。它是在 /系统/图书馆/扩展/
ADB on Mac OS X stops recognizing the attached device after installing EasyTether driver. Use kextload/kextunload to unload from memory the EasyTetherUSBEthernet.kext kernel extension manually. It is in /System/Library/Extensions/
再次感谢你们所有人的帮助与此有关。
Once again, thank you everybody for helping with this.
这篇关于Android的Galaxy S的电话 - 在Mac OSX ADB调试桥故障的文章就介绍到这了,希望我们推荐的答案对大家有所帮助,也希望大家多多支持IT屋!