iOS远程虚拟界面不起作用 [英] iOS remote virtual interface does not work

问题描述

我想捕获iPhone上的净流量.因此，我在官方网站上遵循了Guid.

I want to capture the net traffic on my iPhone. So I followed the guid on the official site.

1. 通过USB将iOS设备连接到Mac.

2. $ rvictl -s UDID

1. Connect iOS device to the Mac via USB.

2. $ rvictl -s UDID

我通过ifconfig -l看到了rvi0接口.我使用tcpdump捕获数据包: $ sudo tcpdump -i rvi0 -n tcpdump:警告:rvi0:该设备不支持混杂模式 (BIOCPROMISC:套接字不支持该操作) tcpdump:警告:rvi0:未分配IPv4地址 tcpdump:禁止详细输出，请使用-v或-vv进行完整协议解码 在rvi0上侦听，链接类型RAW(原始IP)，捕获大小为65535字节

I saw the interface rvi0 via ifconfig -l. I used tcpdump to capture the packet: $ sudo tcpdump -i rvi0 -n tcpdump: WARNING: rvi0: That device doesn't support promiscuous mode (BIOCPROMISC: Operation not supported on socket) tcpdump: WARNING: rvi0: no IPv4 address assigned tcpdump: verbose output suppressed, use -v or -vv for full protocol decode listening on rvi0, link-type RAW (Raw IP), capture size 65535 bytes

然后，我使用iphone5(ios:7.0.2)浏览了一个正常工作的网页.但是还有 tcpdump不会捕获任何pakect.

Then I used my iphone5(ios:7.0.2) browse a web page, which worked as normal. But there is no pakect captured by the tcpdump.

推荐答案

请查看

Please look at the Remote Virtual Interface docs. rvictl -s <<UDID>> just runs the tool with your device. An output line should read something like Starting device <<UDID>> [SUCCEEDED] with interface <<INTERFACE>>To view the packets, enter sudo tcpdump -i <<INTERFACE>> -w trace.pcap When finished with your capture, remove the RVI using rvictl -x <<UDID>> and open trace.pcap (located in your current working directory) using a packet analyzer tool (i.e. WireShark, Cocoa Packet Analyzer, etc.).

这篇关于iOS远程虚拟界面不起作用的文章就介绍到这了，希望我们推荐的答案对大家有所帮助，也希望大家多多支持IT屋！