Arduino按钮指示灯不起作用 [英] Arduino button LED not working

问题描述

当我按下按钮时，它将关闭KY008，但是当我再次单击它时，它不会将其关闭.但是，如果我稍微摇动激光二极管，则KY008会重新打开.

When I push the button it turns the KY008 off but when I click it again it won't turn it off, but if I jiggle the Laser Diode a little bit the KY008 turns back on.

代码:

int LED = 12;
int BUTTON = 4;

void setup(){
   pinMode(LED,OUTPUT);
   pinMode(BUTTON,INPUT);
}

void loop(){
    if(digitalRead(BUTTON) == HIGH){
        digitalWrite(LED,HIGH);
    }else{ 
    digitalWrite(LED,LOW);
    }
}

推荐答案

如果使用INPUT，则需要一个物理上拉(或下拉)电阻(通常为10k).

If you use INPUT you need to have a physical pullup (or pulldown) resistor (typically 10k).

否则，请使用INPUT_PULLUP使用Arduino内部上拉电阻器

Otherwise use INPUT_PULLUP to use the Arduino internal pullup resistors

pinMode(BUTTON, INPUT_PULLUP);

在按下按钮时，请确保按钮将电路接地.

Make sure that your button closes the circuit to ground when pressed.

此外，在阅读按钮时，您还会跳动很多. 防止反弹的最简单方法是在读取之间增加延迟.

Also when reading a button you will have a lot of bouncing. The easiest way to prevent the bouncing is to add a delay between reads.

void loop(){
    if(digitalRead(BUTTON) == HIGH){
        digitalWrite(LED,HIGH);
    }else{ 
        digitalWrite(LED,LOW);
    }
    delay(100);
}

这篇关于Arduino按钮指示灯不起作用的文章就介绍到这了，希望我们推荐的答案对大家有所帮助，也希望大家多多支持IT屋！