如何使Windows Mobile设备中心连接到模拟器 [英] How to get Windows Mobile Device Center To Connect to the Emulator

问题描述

我最近安装了Windows 7，并得出了结论。 Active Sync较旧并且运行不佳，但确实可以运行。经过适当的仪式和咒语，我可以连接到我的设备和模拟器。

I have recently installed Windows 7 and I have come to a conclusion. While Active Sync was old and did not work great, it did work. I could connect to my devices and emulators after the proper rituals and incantations.

我得出的另一个结论是 Windows Mobile Device Center 更糟糕的是，Active Sync曾经是。尽管我摇摇晃晃了多少次，但我无法使它可靠地连接到仿真器（是的，我已将连接类型设置为DMA）。 （虽然仿真器可以很好地连接到Visual Studio调试器。）

The other conclusion I have come to is that Windows Mobile Device Center is worse that Active Sync was. I cannot get it to reliably connect to my emulator (yes, I have set the connection type to DMA) despite how many times I cradle and uncradle. (The emulator connects to the Visual Studio Debugger just fine though.)

要进行主动同步，我必须在安装仿真器后，在连接设置中手动按下连接按钮。我可以通过 Windows Mobile设备中心看到的最大变化是他们删除了该按钮。

With active sync I had to manually press the connect button in the connection settings after cradling the emulator. The biggest change I can see with Windows Mobile Device Center is that they removed that button.

有什么方法可以使Active Sync正常工作在Windows 7上，所以我不必处理这个问题？还是有某种方法可以使其更可靠地连接到Windows Mobile设备？

Is there any way to get Active Sync to work on Windows 7 so I don't have to deal with this? Or is there some way to get it to connect to Windows Mobile Device more reliably?

推荐答案

好吧，我还是找不到在Windows 7上获得Active Sync，但我想出了办法来解决丢失的连接按钮的问题。 （我说咒语，是因为使它正常工作对我来说是晦涩难懂的。）

OK, I have not found anyway to get Active Sync on Windows 7, but I have figured out the incantations to get around the missing connect button. (I say incantations, because getting this to work seems very obscure and arcane to me.)

这就是您要做的事情：

1. 启动模拟器并将其装入


2. 启动 Windows Mobile设备中心。


3. 下一步转到连接设置，然后将其更改为DMA。单击确定。


4. 再次打开连接设置并将其更改为DMA。点击确定。

1. Fire up the emulator and cradle it
2. Fire up Windows Mobile Device Center.
3. Next go to the Connection Settings and change it off of DMA. Hit OK.
4. Open up the Connection Settings again and change it to DMA. Hit OK.

现在应该可以连接了。

这篇关于如何使Windows Mobile设备中心连接到模拟器的文章就介绍到这了，希望我们推荐的答案对大家有所帮助，也希望大家多多支持IT屋！