在设计时无法在标签控件的选项卡之间切换 [英] Cannot switch between tabs of a tab control at design time

问题描述

您好。我正在使用tabcontrol和一些标签。它在导航器中工作正常，但在设计时，无法在选项卡之间切换以在图形模式下插入内容。当我创建了这个tabcontrol时，我可以移动我的选项卡。现在，当我单击选项卡
时，它会在xaml代码中跳转，但不会在Design中跳转。发生了什么？在此先感谢。

解决方案

您好，

您是否正在使用Visual Studio 2010设计师？如果是这种情况，我建议你在同一个项目中创建一个新的TabControl以查看它是否有效，如果有效，请分享源代码然后我们可以缩小原因。如果它不起作用，那么
请在新项目中创建一个新的TabControl，以检查是否是导致问题的项目。如果在新项目中创建新的TabControl，请尽可能分享项目。

如果以上所有都不起作用，请尝试重置visual studio设置，如下所述：

http://blogs.microsoft.co.il/blogs/shair/archive/2008/09/03/reset-the-visual-studio-environment.aspx

Hi. I'm using a tabcontrol with some tabs. it works fine in the navigator but in design time a cannot switch between tabs to insert content in graphic mode. When i have created this tabcontrol, i could move me across the tabs. Now when i click the tab it jump the possition in the xaml code but not in the Design. Whats happening? Thanks in advance.

解决方案

Hi,

Are you using visual studio 2010 designer? If this is the case, I would suggest you creating a new TabControl in the same project to see if it works, if it works, please share the source code and we can then narrow down the cause. If it doesn't work, then please create a new TabControl in a new project to check if it's the project which causes the problem. If creating a new TabControl in a new project works, please share the project if possible.

If all the above don't work, then please try to reset visual studio settings as described below:

http://blogs.microsoft.co.il/blogs/shair/archive/2008/09/03/reset-the-visual-studio-environment.aspx

这篇关于在设计时无法在标签控件的选项卡之间切换的文章就介绍到这了，希望我们推荐的答案对大家有所帮助，也希望大家多多支持IT屋！