连接点 [英] connection points

问题描述

所以，我一直在使用Visio整整2天，所以如果我愚蠢的话请随时告诉我。

So, I've been using Visio for a whole 2 days so if I'm being dumb feel free to tell me.

我建立了一个网络的模板设备机箱。我将控制点水平放置在螺丝孔的水平底部。我将Y固定为0.然后我将CP设置为外部，因为机架CP设置在内部。这样工作，模板折扣
略微偏离我的CP所在的模板边缘。然后我在机箱内添加了更多CP，我想要插入附件。我把它们放在里面。添加内部CP后，它们都不再捕捉。底盘还原了
，卡在模板的边缘，插件根本不会卡扣。 

I built a stencil of a network device chassis. I put control points at the bottom of the shape horizontally where the screw holes are. I pinned the Y to 0. I then set the CP to outside since the racks CP's are set to inside. This worked, the stencil snapped slightly offset from the edge of the stencil right where my CP was. I then added more CPs inside the chassis where I wanted the inserts to attach. I set them to inside. After adding the internal CPs, None of them snapped anymore. The chassis reverted back to snapping at the edge of the stencil and the inserts don't snap at all. 

附带问题，如何在关闭程序并重新打开后编辑主形状。我一直把它拖到屏幕上，然后又作为一个新的模板回到左边。

Side question, how do I edit a master shape after closing the program and reopening it. I have been dragging it onto the screen then back to the left as a new stencil.

推荐答案

Ryan！

如何使用
连接点类型？

这篇关于连接点的文章就介绍到这了，希望我们推荐的答案对大家有所帮助，也希望大家多多支持IT屋！